8.2.2. Removal and installation of the transfer case

The description is provided for models with lever switching of the modes.


  1. Remove forward and back sections of system of production of the fulfilled gases.
  2. Remove forward and back driveshafts (see Removal and installation of driveshafts) — at once after removal of a back shaft muffle an opening of a back epiploon in order to avoid hit in dirt assembly. Try not to damage an epiploon, walls of its landing nest and a pin of the sliding collar.
  3. Disconnect an electrical wiring of sensors switches of provisions (N-4LO and Pacific Rim) and switchings of the modes of the transfer case, forward RPM meter, and an executive electric motor.
  1. Disconnect a control lever switching from the external executive lever.
  1. Prop up the transfer case a transmission jack.
  1. Release fixture and separate a box from assembly of AT.
  1. Installation is made upside-down. Track that all fixture was tightened with the required effort.