4.27. Engine assembly order
Before starting assembly of the engine, make sure available all necessary details, materials and tools to which number the following belongs:
- Standard set of the metalwork tool;
- Dynamometer key with the drive on 1/2 inches;
- The tool for putting on of piston rings;
- The tool for a staving of piston rings;
- Short pieces of a fuel hose for putting on on hairpins of covers of conrod bearings;
- Measuring Plastigage set;
- Set of probes of lezviyny type;
- File with small tooth;
- Fresh motive oil;
- Assembly motive or lubricant on the basis of a molybdenum disulphate;
- Pro-masonry sealant;
- Sealant for fixing of threaded connections.
For saving of time and minimization of volume of the arising problems you make assembly of the engine in the following order:
- Piston rings;
- Bent shaft and radical bearings;
- Conrod and piston;
- Back epiploon of a bent shaft with the holder;
- Soyedinitelny Bridge of covers of radical bearings;
- The oil pump (see Removal, service and installation of the oil pump);
- The case pallet (see Removal and installation of the pallet of a case);
- Heads of cylinders (see Removal, check of a state and installation of a head of cylinders);
- Camshafts and components of the valvate mechanism (see Removal, check of a state and installation of components of the valvate mechanism);
- Gas-distributing belt with cogwheels (see Replacement of a belt of the GRM drive);
- Covers of a gas-distributing belt (see Replacement of a belt of the GRM drive);
- The inlet pipeline and final collectors (see Removal and installation of the inlet pipeline and Removal, check of a state and installation of a head of cylinders);
- GRM covers (see Removal, check of a state and installation of a head of cylinders);
- Driving disk.