10.8. Removal and installation of stupichny assembly and rotary fist


Design of stupichny assembly of a forward wheel


Removal

 PERFORMANCE ORDER

  1. The car also establish to Poddomkratta it on props (see the illustration Scheme of an Institution of Props for fixing of the car in the lifted situation). Remove the corresponding forward wheel.
  2. Disconnect an electrical wiring from the wheel ABS sensor.
  3. Turn out fixing bolts, remove a support and tie up it a wire to suspension bracket elements (see the Head Podvesk and steering).
  4. Turn out fixing bolts and remove a driving flange.
  5. Easy percussions by the hammer with brass brisk release a pin of the external CV JOINT of a power shaft from a nave.
  6. Remove a lock washer.
  7. Having used a special stripper of KV40105400, turn off a nut of the stupichny bearing.
  8. Remove the external bearing and stupichny assembly.
  9. Give fastening bolts to a nave of a rotary fist.
  10. Remove the forelock of a tip of steering draft and give a shpilechny nut.
  11. By means of a stripper of ST9020001 separate a draft tip.


Installation

 PERFORMANCE ORDER

  1. Installation is made as it should be, the return to an order of dismantle of components. Do not forget to adjust properly stupichny bearings (see Adjustment of a pretightness of stupichny bearings of forward wheels). Track that were it is replaced all lock washers and sealing elements. Tighten all fixture with the required effort.