10:13. Removal, check of a state and installation of levers of a back suspension bracket

 PERFORMANCE ORDER

  1. Remove the lever which is subject to service (see Removal and installation of components and assembly of a back suspension bracket).
  2. Visually check assembly of the lever for existence of cracks, deformations and other mechanical damages.
  1. Estimate a condition of rubber-metal plugs, in case of need make their replacement — removal and installation of saylentblok is made by means of couple of special mandrels.

    A — Removal of the rubber-metal plug of the lever of a back suspension bracket
    B — Installation of the rubber-metal plug of the lever of a back suspension bracket

A.

B.

Before installation of a wall of the new plug it is necessary to grease with 1 percent water solution of soap.


Do not try to begin to knock the plug directly the hammer at all!

  1. At installation of levers pay attention to correctness of orientation of fixing bolts and nuts.
  1. Final tightening of fixture of the ends of levers equipped with rubber-metal plugs is made in the unloaded state at the wheels lowered on the earth.