10:10. Replacement of stupichny bearings

Cm. illustration Design of Stupichny Assembly of a Forward Wheel.

 PERFORMANCE ORDER

  1. The car also establish to Poddomkratta it on props (see the illustration Scheme of an Institution of Props for fixing of the car in the lifted situation). Remove the corresponding forward wheel.
  2. Disconnect an electrical wiring from the wheel ABS sensor.
  3. Turn out fixing bolts, remove a support and tie up it a wire to suspension bracket elements (see the Head the Brake system).
  4. Turn out fixing bolts and remove a driving flange.
  5. Easy percussions by the hammer with brass brisk release a pin of the external CV JOINT of a power shaft from a nave.
  6. Remove a lock washer.
  7. Having used a special stripper of KV40105400, turn off a nut of the stupichny bearing.
  8. Remove the external bearing and stupichny assembly.
  9. Remove an epiploon and the internal bearing.
  10. In case of need by means of a brass drift remove external and internal holders.
  11. Wash out components of bearings in solvent and dry them compressed air.

Do not rotate bearings on air.

  1. Attentively examine bearings on existence of signs of wear and mechanical damages. Replace defective components.
  2. Installation is made as it should be, the return to an order of dismantle of components. Track that all sealing elements and lock washers were replaced, and fixture is tightened with the required effort.
  3. In conclusion do not forget to adjust a pretightness of bearings (see Adjustment of a pretightness of stupichny bearings of forward wheels).